MEGASQUIRT COM PORT DRIVER

We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon. If test A fails then you have a serial driver or configuration problem on your computer – consult the documentation that came with the computer or cable. This performs a “loopback” test where the serial signal should go out from the computer, through the short and back into the computer again. Send a private message to Bond. If tests A, B and C all pass but you are having problems with the tuning software, it is most likely a settings problem within the tuning software itself. From there, click System and Maintenance, then click on the Device Manager from there. Take a note of the COM port number listed above.

Uploader: Kigazshura
Date Added: 19 March 2017
File Size: 14.58 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 96037
Price: Free* [*Free Regsitration Required]

For the two windows 7 machines i used the pot adapters: If tests A, B and C all pass but you are having problems with the tuning software, it is most likely a settings problem within the tuning software itself. Select the port as above i. Posting Quick Reply – Please Wait.

Find More Posts by Ben. So before you get into a panic, go through steps here to establish the correct COM port, then ocm the firmware to your MS2. Send a private message to Ben. Quote message in reply? Alternative for Windows Right-click and save portcheck. Stock TPS is still connected since i dont of an aftermarket one installed.

  ASPIRE 5310 TOUCHPAD DRIVER DOWNLOAD

MS2-Extra Serial connection setup. This page has now been superceded, please click here.

MegaSquirt-II Spare Port Configuration

Any characters you type into the top window should be quite literaly “looped back” to the bottom window. Send a private message to Bond. Send a private message to Reverant. Originally Posted by reverant.

Megasquirt Support Forum (MSEXTRA) • com port settings? (View topic)

Ensure your Megasquirt is powered and connected to your computer. So now, either I look like an idiot, or you do.

No part megazquirt this manual may be reproduced or changed without written permission from James Murray, Ken Culver and Metasquirt Ringwood. Use this COM port number when setting up your tuning software. So im not sure where im going wrong but whenever i go to test my serial port the test fails. In this case it is pirt for TunerStudio to report no connection and for the firmware loopback tests to fail. Lift it out progressively by prying up each end a fraction at a time.

  HP PAVILLION ZV 6000 WIRELESS DRIVER DOWNLOAD

Double check the COM port and baud rate. Standard DB9-DB9 straight through serial cable: When done, turn off power, re-install CPU and re-install case.

This performs a “loopback” test where the serial signal should go out from the computer, through the short and back into the computer again.

Find More Posts by Oni.

Megasquirt Support Forum (MSEXTRA)

Originally Posted by v01canic. If you do not then there is a serial problem somewhere. The following errors occurred with your submission.

As shown here this indicates the computer serial end is working ok. For Vista, click the Start button and go megasquitt the Control Panel.

Which version of TunerStudio are you using?

This will bring up the Computer Management screen. Ensuring there are no shorts underneath the board, re-connect your serial cable and apply power. Send a private message to Oni.

Author: admin